#Garage door keypad replacement how to
#Garage door keypad replacement code

Refer to Sections 3-8 on how to program a keypad to the receiver. Re-enter the password.Įnsure the keypad transmitter has been programmed to the Smart Button™ or garage door opener. If you don’t hear 3 beeps that means you have entered the incorrect password. Ensure you hear 3 beeps from the keypad transmitter after entering–

The door opener does not react after I press the button on the keypad transmitter.Ī. DISPOSE USED BATTERIES TTERIES ACCORDING ACCORDING TTO MANUFO MANUFACTURER’S INSTRUCTIONS.ACTURER’S INSTRUCTIONS. RISK OF EXPLOSION IF BARISK OF EXPLOSION IF BATTERTTERYY IS REPLACED BY IS REPLACED BY AN INCORRECTAN INCORRECT TYPE. Close the backplate and re-insert the screw (1).Place the new battery (2) in position.Take out the old battery (2) from the keypad.Undo the screw (1) on the backplate of the keypad.When the operation range is reduced, or when the backlight LED does not flash during operation, it is time to replace the battery. Attach the keypad on the backplate and tighten the screw (1) on the bottom of the keypad.Mount the backplate (B) with the mounting accessories (2).Please refer to Section 12 on how to insert the battery. 1.5-volt Alkaline type (AAA(AAA size) battery size) battery required.Undo the screw (1) on the bottom side of the keypad (A) and remove the backplate.Because the keypad has been reset, follow Sections 3-7 for initial setup and to program the keypad to the operator.Keep holding both buttons for about 5 seconds until you hear a long beep.While holding both buttons put the battery back in.While the battery is out, hold and buttons together.If you forget your pin code, to reset the pin code:

#Garage door keypad replacement code

To open and close the door, press the new pin code plus #.The keypad is already programed to the operator and this step is not required. Do not press the learn button on the operator.To Change the Keypad Pin Code After Initial Setup If additional remote needs to be programmed, press the up button, the remote icon will flash again. If a remote is programmed, the remote icon will stay on. Press the PROG button again until the remote icon appears on the display.Press and hold the PROG button on the LCD Wall Console for 10 seconds until the “PROG” icon appears on the display.Program Keypad to IQ Garage Door or Opener įollow the same steps for programming additional operators to the keypad for multiple doors.Įxample, Door 2 pin: 1234#2, Door 3 pin: 1234#3 and Example, Door 2 pin: 1234#2, Door 3 pin: 1234#3 and Door 4 pin: 1234#4.Door 4 pin: 1234#4. Pin code plus plus for multiple door operation.Pin code plus # for single door operation.Within 30 seconds, activate the keypad by entering:.Press the “Learn” button on the opener, the yellow LED will flash for 30 seconds.Program Keypad to EQ Garage Door Opener or Smart Button™ Receiver. To program the keypad to IQ Garage Door Opener, follow section 8. To program the keypad to EQ Garage Door Opener or Smart Button™ Receiver, follow section 6.

Enter the new pin code from 2 to 8 digits plus *, twice.Press then separately and you will hear 2 beeps to confirm you have enabled the Multiple-Door Operating Mode.Enter the factory default pin code plus *.